44952001TH Rev.2
3-13
Oki Data CONFIDENTIAL
3. MFP INSTALLATION
3.5.2 Power Cable Connection
Conditions for Power Supplies
•
Observe the following conditions:
Alternate Current (AC) : 110~127VAC (Range 99~140VAC)/
220~240VAC (Range 198~264VAC)
PowerSupplyFrequency:50Hzor60Hz±2%
•
Use a voltage regulator when the power supply is not stable.
•
The maximum power consumption of this MFP is 1170W. Confirm that the power
supply has sufficient extra capacity.
It may expose you to electric shocks or cause a fire.
• Neverfailtoswitchoffthepowersupplyatthetime ofconnectionorremovalof the
electric cord and earth cable.
• Alwaysconnecttheearthcabletotheearthterminalequippedonlyforthatpurpose.
Never connect the earth cable with water pipe, gas pipe, telephone cable earth
terminal, lightening rod, etc.
• Always grasp the power plug at the time of connection and removal of the electric
cord.
• Alwaysmakesurethattheelectricplugisinsertedfullyintotheoutlet.
• Donotconnectordisconnecttheelectricplugwiththewethand.
• Do not install the electric cord at the place liable to be stepped on and do not put
things on the electric cord.
• Donotbundleuportieuptheelectriccord
• Donotusethedamagedelectriccord.
• Donotputmanyloadsononeelectricoutlet.
• DonotconnectthisMFPtothesameoutletwithotherelectricmachines.Particularly,
erroneous operation may occur by electric noise when the same outlet is shared by
the air conditioner, duplicator, shredder, etc. at the same time. When the same outlet
had to be used, use a noise filter or noise cut transformer on the market.
• Usetheattachedelectriccordonly.
• Donotuseanextensioncord.Usethecordofoverrating15Aifyouhadtouseone.
• Whenyouusetheextensioncord,theMFPmaynotoperatenormallyduetothedrop
of AC voltage.
• Donotshutdownthepowersupplyorremovethepowerplugwhileprinting.
• DisconnectthepowercordwhentheMFPwouldnotbeusedforsomelongwhiledue
toconsecutiveholidaysorjourney.
As to the connection of the electric cord and earth cable, explain fully to the customer
showing the User’s Manual.
Turning ON the Power
(1) Insert the electric cord in the MFP.
AC cord (240V) AC cord (120V)
(2) Plug the AC cord into the electric socket.
(3) Check that no documents are on the document
glass or ADF, and the ADF cover is closed.
(4) Hold down the power switch for about a second
to turn on the power.
The copy standby screen is displayed after the cachine be came ready status.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
