Oki ML280 Elite User Manual

> 43
Rear Feed, Repeating Paper Jams
If the paper keeps jamming, you may have:
> defective paper
> misaligned paper
> bits of paper in the paper path
Defective Paper
Replace the defective paper with a fresh stack.
Misaligned Paper
1. Turn the printer OFF.
2. Use the platen knob to back the paper all the way out of the
printer.
3. Tear off a couple of sheets of paper, leaving a new, clean,
square-cut edge.
4. Reload the paper and turn the printer back ON.
Bits of paper in the paper path
Depending on which paper feed method you are using, remove any
accessories, open the access cover and remove any debris from the
paper path.
WARNING!
l Always ensure that the printer is switched OFF and that the power
supply lead is disconnected.
l If the printer has been recently used, the printhead may be HOT!

Oki ML280 Elite Specifications

General

Color	No
Character pitch	10, 12, 15, 17.1, 20 cpi
Maximum resolution	240 x 216 DPI
Typestyles supported	Double height, Double width, Emphasised, Enhanced, Italics, Overscore, Underline
Maximum number of copies	3 copies
Maximum print speed (draft)	240 cps
Maximum printing width (columns)	160
Mean time between failures (MTBF)	20000 h
Product color	Gray
Sound pressure level (printing)	58 dB
Sound pressure level (quiet mode)	51 dB
Standard interfaces	Parallel, USB 2.0
Optional connectivity	Serial (RS-232), Serial (RS-422)
AC input voltage	220 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (typical)	60 W

Weight and Dimensions

Depth	275 mm
Width	372 mm
Height	80 mm