Page: 36
Service Guide ML390/391
Chapter 3 Maintenance & Disassembly
3.1 MAINTENANCE
3.1.01 General Information
This section lists the parts replacement, adjustment, cleaning, and lubrication procedures.
Disassembly should not be performed unless absolutely necessary.
NEVER
perform disassembly on a
malfunctioning unit until you have followed the failure analysis procedures in Section Four of this Service
Handbook.
Follow the procedures listed in
Adjustments and Service Settings
. Adjustments may be required when
either consumables or parts are replaced. Failure to perform these procedures could result in
unnecessary service calls.
Cleaning procedures must be performed correctly if high print quality is to be achieved.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
To Next Page
Loading...
Need help?
General
