Using your printer > 40
P
RINTER
RESET
Clearing some error conditions requires that you reset (reinitialise) the printer. To do this:
1. Press and release SEL (1) to take the printer off line.
The SEL light goes out.
2. Press and hold SHIFT
(2), then press the RESET/CHARACTER PITCH key (5).
C
HANGING
EMULATIONS
Make sure paper is loaded.
1. Press and hold SHIFT
(2), then press SEL (1).
2. Press LF(3).
The following line will print:
3. Press TEAR (4) repeatedly until the emulation you wish to select prints in the
right-hand column.
4. Press and hold SHIFT (2), then press SEL (1) to save your setting and exit the Menu
Mode.
NOTE
Pressing SHIFT and RESET reinitialises the printer, but does not affect any
menu settings and does not reset the printer to the factory defaults. For
information on resetting the printer to the factory defaults, see “Resetting the
menu to the factory defaults” on page 41.
Printer Control Emulation Mode IBM PPR (ML5520ECO/ML5521ECO)
EPSON LQ (ML5590ECO/ML5591ECO)
1
2
3
4
5
To Next Page
Loading...
Need help?
General
