9 Note of Chinese
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
9-8
关于通过关机软件退出 OS 后的自动重启
● 在特定计算机*1 上，停电时会发生通过自动关机软件退出 OS、然后计算机立即重启的现象。
这种情况可能会导致不间断电源在计算机重启中或启动后停止运转，以致文件或硬盘受损。
将计算机 BIOS 设定内的 POWER MANAGEMENT 改为 Disable（无效）即可防止此现象的发生。
*1） 特定计算机：此现象已在 MICRON 生产的 Millennia Mme 上得到确认。
● 计算机无法自动重启时，请在计算机的 BIOS 设定中选择“输入电源恢复后的系统启动”设定
项目（例：Restore on AC/Power Loss）、并将其设定修改为“输入电源恢复后启动系统”（例：
Power On）。另外，根据所使用的计算机的不同，BIOS 的设定方法或显示项目有所差异。
请查看所使用的计算机使用说明书、或联系计算机支持中心。
●
若您正在探讨输入电源恢复后使计算机自动重启的系统课题，则请选择满足以下条件的计算机。
关于通过输入电源进行供电时的计算机运转状况，请查看计算机使用说明书、或联系计算机支
持中心。
【条件】
通过输入电源供电时，计算机无需开启自身的电源开关即可启动。
● 停电时，若刚退出即恢复供电，不间断电源则会自动启动并开始供电。无需运转连接设备时，
请关闭设备的电源开关。
● 使用附带的自动关机软件后，还可设定为无需自动重启。
10 References
10-1 Specifications
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
10-1
10
10 References
10-1 Specifications
Model BN50T BN75T BN100T BN150T BN220T BN300T
Method
Operation method Line-interactive method
Cooling method Natural air cooling Forced air cooling
Input
Rated input voltage 100 V AC
Input
voltage
range
Standard sensitivity setting
89±2 to 118±2 V AC
Sensitivity setting: Low
84±2 to 118±2 V AC
Sensitivity setting: High
89±2 to 113±2 V AC
Frequency 50/60Hz±4Hz
Input Maximum current 7.5 A 12 A 15 A 20 A 30 A 40 A
)dednuorg( eriw-owt ,esahp-elgniS esahP
Input protection NFB (10A) NFB (13A) NFB (20A) NFB (25A) NFB (45A) NFB (45A)
AC input plug 3P (NEMA 5-15P)
*1
)P03-5L AMEN( P3
*2
Output
Rated output capacity
500 VA/450 W 750 VA/680 W
1000 VA/900 W
1500 VA/1350 W
*1
2200 VA/1980 W
3000 VA/2700 W
*2
Voltage
Commercial opera-
tion
90±3 to 114V±3 V AC (AC input plug Sensitivity setting: Normal)
84±3 to 114V±3 V AC (AC input plug Sensitivity setting: Low)
90±3 to 110V±3 V AC (AC input plug Sensitivity setting: High)
Backup operation 100 V AC±6%
Frequency
Commercial operation
Synchronized with input frequency
Backup operation 50/60Hz±0.1Hz
Wave-
form
Commercial operation
Sine wave
Backup operation Sine wave
Distortion rate
*3
20% max. (Rectified load, at rated output)
15% max. (Rectified load, at rated output)
)dednuorg( eriw-owt ,esahp-elgniS esahP
Output receptacle NEMA 5-15R x 6 NEMA 5-15R x 8
NEMA 5-15R x 8
NEMA 5-20R x 2
Battery
yrettab dael delaeS epyT
Voltage / Capacity x Quantity 12 V / 9 Ah x 2 12 V / 7.8 Ah x 4 12 V / 7.8 Ah x 8
Backup time (25°C, initial characteristics)
8.5 min. or more 4 min. or more 9 min. or more 4.5
min. or more 7 min. or more
4.5
min. or more
Charging time 4 hours 90%
Battery life
Ambient temperature 25°C
Expected life: 5 years
Envi-
ronment
Operating environment tem-
perature/ humidity
0˚C to 40˚C, 25 to 85%RH with no condensation
Storage temperature -15˚C to 50˚C, 0 to 90%RH with no condensation
Safety standard / RoHS di-
rective compliance
UL1778 / RoHS compliant / CE
Disturbance voltage / Radiated
interference field strength
VCCI Class A
Internal power consumption
(normal/maximum)
15W (*4) / 50W (*5) 24W(*4) / 100W (*5) 30W (*4) / 200 W (*5)
Bd05 Bd54 esioN
Dimensions (W x D x H)
140 mm x 359 mm x 167 mm
172 mm x 415 mm x 225 mm 200 mm x 403 mm x 403 mm
gk 02 .xorppA gk 11 .xorppA tinu fo thgieW
Approx. 36 kg (BN220T)
Approx. 37 kg (BN300T)
*1:
For BN150T, the maximum output (1.5 kVA/1.35 kW) cannot be used with the standard input plug (NEMA
5-15P). To use with maximum output, replace with a 20A plug. (purchased separately)
*2:
For BN300T, the maximum output (3.0 kVA/2.7 kW) cannot be used with the standard input plug
(NEMA L5-30P). To use with maximum output, connect to the terminal block (purchased separately).
The standard equipment input plug (NEMA L5-30P) cannot be connected to a household receptacle.
*3: Rectified load, rated load, in Battery Mode (except in BL state)
*4: Rated load/ Rated input voltage/ When fully charged
*5: Rated load/ Rated input voltage/ When battery charge current is at maximum
To Next Page
Loading...
Need help?
General
