Omron BN50T User Manual

3 Check and start operation
3-1 The name and function for the operation and display
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
3-2
3-1-3 Switch
Sign
of the
figure
Label Name Description
E Power switch ON: Press and hold the power switch of the UPS for 2 seconds or
longer. After a few seconds, the power output from the UPS
begins.
OFF: Press and hold the power switch of the UPS for 2 seconds or
longer in ON state, then the power output from the UPS stops.
Additional Information:
 If the AC input plug is connected to the wall outlet (commercial power
source), then the battery will be charged regardless of the power
switch.
F “Up” switch Move cursor up or increase a value
G “Down” switch Move cursor down or decrease a value
H “ESC” switch Return to menu or cancel
Stop the beeper by pressing for 0.5 seconds or longer
I “Enter” switch Select the menu item or set the value
3 Check and start operation
3-1 The name and function for the operation and display
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
3-3
3
3-1-4 Beep sound
 Type of beep sound.
 Intermittent
0.5-second
intervals:
ON
OFF
0.5second
2-second
intervals:
2 second
ON
OFF
1-second
intervals:
1 second
ON
OFF
4-second
intervals:
4second
ON
OFF
 Continuous
Continuous
ON
OFF
Additional Information
• You can set the conditions on which the beep sounds to ”OFF at Battery Mode”
or “OFF at Anytime”, with “Setting” - “Local Setting” - “Audible Alarm” in the menu
on the LCD.
 Stopping the beep sound
When the beep is sounding, you can stop it by pressing and holding the “ESC” switch for
0.5 seconds or longer.

Omron BN50T Specifications

General

Brand	Omron
Model	BN50T
Category	UPS
Language	English