Omron BN50T User Manual

Introduction
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
2
IMPORTANT SAFETY INSTRUCTION
1. SAVE THESE INSTRUCTIONS.
This manual contains important instructions for
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T that should be followed
when using the UPS and batteries.
2. SYMBOL
This symbol indicates earth ground.
This symbol indicates turning on/off UPS.
3. INTERNAL BATTERY
Internal battery voltage is 24VDC for BN50T/BN75T,
48VDC for BN100T/BN150T, and 96VDC for BN220T/BN300T.
4. TEMPERATURE RATING
The maximum ambient temperature of the UPS is 40°C.
5. ENVIRONMENT
The unit is intended for installation in a temperature controlled, indoor area free
of conductive contaminants.
Procedure from installation to operation
BN50T/BN75T/BN100T/BN150T/BN220T/BN300T
3
Procedure from installation to operation
The procedure from installation to operation is shown below.
Read “Safety precautions”
Page 7
Start
Remove the product from the
package and check the contents
1. Preparation
Perform installation and
connection
2. Installation and connection
Are you using either of the
following functions?
- UPS monitoring software
- Contact signal
- SNMP/Web card
Check the operation
3. Check and start operation
(Charge the battery *)
Operate
3. Check and start operation
Perform maintenance
and inspection
4. Maintenance and Inspection
Replace the battery
4.2 Replacing the battery
The battery must
be replaced
No
Yes
5.To perform shutdown processing
of the devices such as your PC
when a power failure occurs
6. Using contact signal functions
7. Using an SNMP/Web card
Yes
* The UPS has been charged prior to shipment.
However, if it is left for a long period of time, it
may have self-discharged.
We recommend charging the UPS before using it.
Installation/connection
Perform maintenance
and inspection
Preparation for operation
No
Operate

Omron BN50T Specifications

General

Brand	Omron
Model	BN50T
Category	UPS
Language	English