To Next Page

To Previous Page

5-3 Maintenance Mode

The set values of the K3NX can be initialized and field calibration of the K3NX is

possible in maintenance mode. The operations of the K3NX in this mode are de-

scribed below.

5-3-1 Maintenance Mode

• The K3NX will be in maintenance mode if the Mode and Shift Keys are pressed

simultaneously while the K3NX is turned on.

• The K3NX in maintenance mode will go into RUN mode if the Escape Key is

pressed.

RUN mode

Press the Mode and Shift Keys

while turning the K3NX on.

Power On

Press the Escape and Up

Keys for 1 second.

Maintenance mode

RUN mode

1 second

Setting mode

Protect mode

5-3-2 Initialization

Follow the steps described below to reset the set values of the K3NX to factory-

set values.

1, 2, 3... 1. Press the Mode and Shift Keys simultaneously while turning the K3NX on.

The mant maintenance mode setting will be displayed.

Set Value LED Display Model Basic Model

2. Press the Mode Key for more than one second. The reĆin initialization set-

ting will be displayed.

Set Value LED Display Model Basic Model

3. Press the Up Key to display no.

Set Value LED Display Model Basic Model

Maintenance Mode

Section 5-3

AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr

Omron K3NX User Manual

Other manuals for Omron K3NX