3
Hysteresis The established setting value includes a hysteresis setting to prevent “chatter-
ing” of the output when the measured value fluctuates in the vicinity of the setting
values.
Hysteresis is enabled when the measured value is starts to become smaller than
the HH and H setting values and larger than the LL and L setting values.
Refer to Hysteresis, page 46.
Startup Compensation Time The startup compensation time parameter keeps the measurement operation
from sending an unnecessary output corresponding to instantaneous, fluctuat-
ing input from the moment the K3NX is turned ON until the end of the preset peri-
od.
Refer to Startup Compensation Time, page 44.
Remote/Local Selection The K3NX can be operated remotely through a host computer or locally with key
inputs.
Remote Mode: For programming remotely by downloading setup parameters
from a host computer via RS-232C, RS-485, or RS-422.
Local Mode: Programming is performed with the front panel key input.
Refer to Remote/Local Programming, page 54.
Average Processing Average processing prevents the display from fluctuating due to unstable input.
Simple average processing or movement average processing can be selected.
Refer to Average Processing, page 41.
1-2 Front of the Meter
Comparative output
status indicators
PV display
Mode Key
Status indicators
SV display status
indicators
Teaching indicator
Unit of measure
SV display
Shift Key
Escape Key
Up Key
RESET/TEACH Key
Five-digit (–19999 to 99999), seven-segment, 14.2-mm-high LED display with a
programmable decimal point.
The displays show the process value, maximum value, minimum value, opera-
tions/parameters when setting, and error messages.
Front of the Meter
Section 1-2
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General
