Appendix 4 Using NT-AL001 Converters
Appendix 4 Using NT-AL001 Converters
This section outlines the external dimensions, procedure for mounting and removal, and
specifications of an NT-AL001 RS-232C/RS-422A Converter. Refer to this information
when designing the control panel. For details, refer to the instruction manual supplied with
the NT-AL001.
A-4-1 Dimensions
110
30 (W)
×114 (H) × 100.2 (D) mm: with the RS-422A terminal block cover closed
30 (W)
×114 (H) × 119.5 (D) mm: with the RS-422A terminal block cover open
A-4-2 Methods for Mounting and Removal
The RS-232/RS-422 converter unit (NT-AL001) can be mounted on a DIN rail or in an op-
eration panel.
The RS-422A terminal block of the converter unit can be easily removed.
Mounting to a DIN Rail
Latch the top part of the rear face of the converter unit (a in the figure) onto the top edge
of the DIN rail, and push the unit in the direction indicated by b in the figure.
Now fit end plates at the right and left of the converter unit to secure it and ensure that it
cannot shift laterally.
A-25
To Next Page
Loading...
Need help?
General
