133
Revision History
A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
Cat. No. W325-E1-04
Revision code
The following table outlines the changes made to the manual during each revision. Page numbers refer to the
previous version.
Revision code Date Revised content
1 August 1997 Original production
2 June 1998 Pages xii to xiv: Precautionary information changed.
Pages 10, 67: “Approximately” added to the conversion time of 0.3 ms in note
4.
Page 20: CPU Unit model numbers corrected.
Pages 27, 54, 92: I/O table information added to the Caution.
Page 38: “Approximately” added to the conversion time of 0.3 ms in note 3.
Page 67: Conversion time addition corrected from “0.9 ms” to “0.3 ms.”
Page 105: Error code F0 added to the table.
Pages 116, 117: Sample Program 5: Scaling rewritten and added to.
3 May 1999 Pages xii to xiv: Precautionary information changed.
Pages 15, 73: “Line Breakage while Using Voltage Input” section added.
Pages 27, 30, 31, 54, 58, 60, 92, 94, 96, 97, 100, 103: Offset adjustment and
gain adjustment information added to the Caution.
Page 41: “Analog Input Unit” corrected to “Analog Output Unit” in the first sen-
tence of 3-2-2 Unit Number Switch.
Page 47: Left column of the IR allocation table corrected.
Page 89: Loop 1 and 2 bit settings for Specifying I/O Relationships corrected.
Pages 113, 116, 117, 120: Minor corrections to the sample program informa-
tion.
Page 127: Loop 1 and 2 bit settings for Use Designation corrected.
4 June 2003 Page xii: Safety precautions added.
Page xiii: “Power Supply Units” added in one place.
Page 4: Information on mounting limitations added.
Page 38: Note added after table.
Page 66: Two lines added to table.
Page 67: Note added after table.
To Next Page
Loading...
Need help?
General
