CLI Hardware View
Service Processor
The service processor behaves differently from other component nodes. Instead of providing
a list of components, it presents a set of network properties that can be configured from the
storage appliance. The following properties control the behavior of the service processor
network management port.
TABLE 7
Properties for the Service Processor Network Management Port
Property Description
MAC Address Hardware MAC address. This is read-only
IP Address Source Either 'DHCP' or 'Static'. Controls whether DHCP should be used on the
interface.
IP Address IPv4 Address, when using static IP configuration. IPv6 is not supported.
Subnet Dotted decimal subnet, when using static IP configuration.
Default Gateway IPv4 default gateway address.
Changing multiple values in conflicting ways (such as changing static IP assignments while in
DHCP mode) has undefined behavior.
CLI Hardware View
Hardware status details are available in the CLI under the maintenance hardware section. Use
the show command to list the status of all components. The list command will list available
chassis, which can be selected and then viewed using show.
hostname:> maintenance hardware show
Chassis:
NAME STATE MANUFACTURER MODEL
chassis-000 0839QCJ01A ok Sun Microsystems, Inc. Sun Storage 7320
cpu-000 CPU 0 ok AMD Quad-Core AMD Op
cpu-001 CPU 1 ok AMD Quad-Core AMD Op
cpu-002 CPU 2 ok AMD Quad-Core AMD Op
cpu-003 CPU 3 ok AMD Quad-Core AMD Op
disk-000 HDD 0 ok STEC MACH8 IOPS
disk-001 HDD 1 ok STEC MACH8 IOPS
26 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
To Next Page
Need help?
General