Outback Power Systems FLEXMAX 80 User Manual

30
PB
The ERROR OUTPUT default state is On, meaning
12 VDC is present at the AUX terminal. If the
FLEXmax 80 has not charged the batteries for 26
hours or more continuously, the inaudible ERROR
OUTPUT goes into an O state. The ERROR OUTPUT
is intended for remote locations to signal (e.g., a
telecommunication signal to a computer) when the
FLEXmax 80 has not charged the battery for 26 hours
or more. Press the <SET> soft key to advance to the
ERROR OUTPUT volt screen.
The ERROR OUTPUT screen displays the number of
hours the FLEXmax 80 has not been producing any
power (the number of hours in Sleep Mode). Press
the <VOLT> soft key to adjust the ERROR LOW BATT
VOLTS screen.
User-determined value—not less than 10V—will
trigger an alarm or, through a user-supplied modem,
send a signal from a remote installation indicating
the battery charge has reached this value. This
informs the user of a low battery problem. Use the
< - >
and < + > soft keys to change this value. Press
the <BACK> soft key to return to the AUX MODE
ERROR OUTPUT screen.
Press the <EXIT> soft key to bring up the original
ERROR OUTPUT screen.
Press the <NEXT> soft key to view the Night Light
screen.
AUX MODE
ERROR OUTPUT
Output: On On
EXIT NEXT SET MODE
On
O
Auto
AUX MODE
ERROR OUTPUT
01 hrs
EXIT VOLT
ERROR LOW BATT VOLTS
<11.5
BACK - +
AUX MODE
ERROR OUTPUT
01 hrs
EXIT VOLT
ERROR OUTPUT
AUX MODE
ERROR OUTPUT
Output: On On
EXIT NEXT SET MODE

Outback Power Systems FLEXMAX 80 Specifications

General

Brand	Outback Power Systems
Model	FLEXMAX 80
Category	Controller
Language	English