1.8.2 Refusing Incoming Calls (Do Not Disturb [DND])
–
Do Not Disturb (DND)
– Switching FWD/DND Status Using Fixed FWD/DND Button
Do Not Disturb (DND)
You can set this feature to prevent incoming calls from ringing at your extension. This can be useful, for
example, when you are in a meeting or busy.
To set/cancel
On-hook.
Enter 1 to set
or 0 to cancel.
PT/SLT/PS/SIP Extn.
Set
Cancel
1
0
OR
Off-hook.
Enter 71.
1
2
0
Both Calls
Intercom Calls
Outside Calls
OR
OR
17
Enter 0 to 2 as you desire.
C.Tone
• When using a proprietary telephone, you can set or cancel Do Not Disturb by pressing the
FWD/DND button (fixed button) instead of " 710".
• The FWD/DND button light shows the current status as follows:
Off: Both features are not set.
Red on: FWD mode
Flashing red slowly: DND mode
• The system has two modes: (1) FWD/DND Cycle Switch Mode and (2) FWD/DND Setting
Mode. Ask your manager what mode your system is in if you are not sure.
(1) When in FWD/DND Cycle Switch Mode:
Pressing the FWD/DND button (fixed button) while in idle status will cycle the setting as shown
below:
(2) When in FWD/DND Setting Mode:
Pressing the FWD/DND button (fixed button) while in idle status allows you to switch the
FWD/DND status and set the FWD destination (refer to " Switching FWD/DND Status
Using Fixed FWD/DND Button").
Note
A
FWD/DND button (customised button) is always in FWD/DND Cycle Switch Mode: the
mode cannot be changed.
User Manual 129
1.8.2 Refusing Incoming Calls (Do Not Disturb [DND])
To Next Page
Loading...
Need help?
General
