2. Getting Started/Basic Operations
32
Changing the Lens
By changing the lens, you will increase your picture taking-options and further your
enjoyment of the camera. Change the lens using the following procedure.
•
Check that the camera is turned off.
• When attaching or detaching the interchangeable lens (H-FS12032/H-FS35100), retract the
lens barrel.
• Change lenses where there is not a lot of dirt or dust. Refer to P359 when dirt or dust gets on
the lens.
• Attach the lens cap.
While pressing on the lens release button B,
rotate the lens toward the arrow until it stops
and then remove.
• Hold and rotate the base area of the lens A.
• When the lens is removed from the camera body, make sure to attach the body cap to the
camera body and attach the lens rear cap to the lens.
Detaching the lens
To enable/disable the shutter release without lens.
> [Custom] > [Shoot w/o Lens]
[ON]: Shutter will operate regardless of the lens on the unit.
[OFF]: Shutter will not operate when a lens is not attached to the camera body or is
not attached correctly.
•
When using a Leica lens mount adaptor (DMW-MA2M, DMW-MA3R: optional), set it to [ON].
MENU
To Next Page
Loading...
Need help?
General
