324
13. Others
Optional accessories
• Some optional accessories may not be available in some countries.
Optional flashes (DMW-FL360L/DMW-FL580L: optional) provide a wider flash recording
range than the flash (supplied) does.
When attaching a flash, remove the hot shoe cover attached to the camera. (P203)
•
To change the settings for external flashes on the camera, refer to P206.
• Refer to P211 about the settings for the wireless flash.
• You can set the aperture value, the shutter speed and the ISO sensitivity on the camera even
when attaching the external flash.
• Some commercial external flashes have synchro terminals with high-voltage or reversed
polarity. Using such extra flashes may cause a malfunction or the camera may not operate
normally.
• If you use commercially available external flashes with communication functions other than the
dedicated one, they may not operate normally or they may be damaged. Do not use them.
• Even if the external flash is turned off, the camera may enter the external flash mode when the
external flash is attached. When you are not using the external flash, detach it.
• The camera will become unstable when attaching the external flash, it is recommended to use
a tripod when taking picture.
• Detach the external flash when carrying the camera.
• When attaching the external flash, do not hold only the external flash because it may detach
from the camera.
• If you use the external flash when the White Balance is set to [ ], finely adjust the White
Balance depending on the picture quality. (P129)
• If you record at close range with a wide angle, light from the flash may be blocked by the lens,
darkening the lower part of the screen.
• Read the operating instructions of the external flash for details.
External Flash (optional)
When using other commercially available external flashes without
communication functions with the camera (DMC-GM5)
•
It is necessary to set the exposure on the external flash. If you want to use the external flash
in Auto Mode, use an external flash that allows you to set the aperture value and the ISO
sensitivity to match the settings on the camera.
• Set to Aperture-Priority AE Mode or Manual Exposure Mode on the camera and then set the
same aperture value and ISO sensitivity on the external flash. (The exposure cannot be
compensated adequately due to the change on the aperture value in Shutter-Priority AE
Mode and the external flash cannot control the light adequately in Program AE Mode
because the aperture value cannot be fixed.)
To Next Page
Loading...
Need help?
General
