Absolute rotary encoder P**58
Diagnostic messages
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
Date of issue 01/15/04
29
6.2.8 Profile version
The profile version of the rotary encoder is stored in diagnostic Octets 24 and 25:
6.2.9 Software version
The software version of the rotary encoder is stored in diagnostic Octets 26 and 27.
6.2.10 Operating time
Diagnostic Octets 28 ... 31 contain the operating time of the device. When power
supply voltage is applied, the "Operating time" value is stored again once every 6
minutes in the rotation encoder in increments of 0.1 hours.
6.2.11 Reference point shift
The zero point offset is available for output in diagnostic Octets 32 ... 35.
6.2.12 Resolution as assigned by parameter
Diagnostic Octets 40 ... 43 store the resolution per revolution as assigned by
parameter. This value is only valid if the gear factor has been calculated with the
setting "Resolution per revolution" in the parameter mask (see section 5.1.3).
6.2.13 Overall resolution as assigned by parameter
The overall resolution assigned by parameter or calculated is stored in diagnostic
Octets 44 ... 47.
6.2.14 Serial number
Diagnostic Octets 48 ... 57 are provided for a serial number according to the encoder
profile.
Revision no. Index
Octet 24 25
Bit 15 ... 8 7 ... 0
Data
2
7
... 2
0
2
7
... 2
0
Revision no. Index
Octet 26 27
Bit 15 ... 8 7 ... 0
Data
2
7
... 2
0
2
7
... 2
0
To Next Page
Loading...
Need help?
General
