Phoenix Contact EV Charge Control Basic User Manual

EV Charge Control Basic
20 / 68
PHOENIX CONTACT 106377_en_04
4.4 Mounting on the DIN rail
Figure 4-6 Mounting/removal
The device can be mounted in any position on the DIN rail.
Mounting on a DIN rail (A)
1. Place the device onto the DIN rail from above.
2. Push the front of the device toward the mounting surface until it engages with a click.
Removing from the DIN rail (B)
3. Push down the locking latch using a screwdriver, needle-nose pliers or similar.
4. Pull the bottom edge of the device slightly away from the mounting surface.
5. Pull the device diagonally upward from the DIN rail.
A B

Phoenix Contact EV Charge Control Basic Specifications

General

Brand	Phoenix Contact
Model	EV Charge Control Basic
Category	Controller
Language	English