Dell'Orto
DELL'ORTO CARBURETTOR
Specification Desc./Quantity
Type PHVA 17.5 RD
Diffuser diameter Ø 17.5
Adjustments reference number 8440
Maximum nozzle: 53
Maximum air nozzle (on the body): Ø 1.5
Tapered pin stamped code: A22
Pin position (notches from above): 1
Diffuser: 209 HA
Minimum nozzle: 32
Minimum air nozzle (on the body): Free
Secondary minimum air hole Ø 2.5
Initial minimum mix screw opening: 1 1/2
Starter jet 50
Starter air nozzle (on the body): Ø 1.5
Stroke of starter pin: 11 mm
Fuel inlet hole Ø 1.0
Tightening Torques
STEERING ASSEMBLY
Name Torque in Nm
Upper steering ring nut (safety locks) 35 to 40 Nm
Lower steering ring nut (safety locks) 8 to 10 Nm
Handlebar fixing pin (safety locks) 45 to 50 Nm
FRAME ASSEMBLY
Name Torque in Nm
Swinging arm-engine pin (safety locks) 33 to 41 Nm
Swinging arm-frame pin (safety locks) 64 to 72 Nm
Shock absorber - frame nut (safety locks) 20 to 25 Nm
Shock absorber-engine pin (safety locks) 33 to 41 Nm
Rear wheel axis (safety locks) 104 to 126 Nm
Bolt holding stand to the engine 18 to 19 Nm
Side stand fixing screw 12 ÷ 20
Side stand bracket fixing screw 15 ÷ 20
Rear rim fixing screw 20÷25
FRONT SUSPENSION
Name Torque in Nm
Front wheel axle nut (safety locks) 45 to 50 Nm
Wheel axle clamp screw 6 ÷ 7 Nm
Lower leg screw 15 to 20 Nm
Hydraulic cartridge stem nut 15 to 18 Nm
FRONT BRAKE
Name Torque in Nm
Viti fissaggio coperchio pompa freno 1,5 ÷ 2 Nm
NRG Power DT Characteristics
CHAR - 7
To Next Page
Loading...
Need help?
General