To Next Page

To Previous Page

Automatic transmission

Transmission cover

- Loosen the 15 screws and remove the transmis-

sion cover with the aid of a mallet.

N.B.

THE CRANKCASE IS SLIGHTLY BLOCKED BY

THE TIGHT FIT BETWEEN THE SHAFT OF THE

DRIVEN HALF-PULLEY AND THE BEARING

HOUSED ON THE CRANKCASE.

Kickstart

- Remove the seeger ring located on the exterior

of the crankshaft.

- Dismantle the dog gear from its seat, slackening

the tension that the toothed sector applies to it by

means of the spring; to do this, it is necessary to

rotate the toothed sector slightly (see the figure).

CAUTION

WHILE REMOVING THE TOOTHED SECTOR,

BE VERY CAREFUL OF THE SPRING TEN-

SION: IT COULD CONSTITUTE A HAZARD FOR

THE OPERATOR.

- Upon refitting, apply the recommended grease to

the bushing, to the spring and along the toothed

sector.

- Use the special tool for the charging of the spring,

as shown in the figure.

- Refit the seeger ring after checking that it is in

good condition.

Specific tooling

020261Y Starter spring fitting

PIAGGIO NRG Power DT User Manual

Questions and Answers: