PIAGGIO NRG Power DT User Manual

Refitting the clutch
- Preassemble the driven pulley group with spring,
sheath and clutch.
- Position the spring with the sheath
- Insert the components in the tool and preload the
spring being careful not to damage the plastic
sheath and the end of the threaded bar.
- Reassemble the nut securing the clutch and tight-
en to the prescribed torque.
CAUTION
SO AS NOT TO DAMAGE THE CLUTCH NUT
USE A SOCKET WRENCH WITH SMALL
CHAMFER.
CAUTION
POSITION THE NON-CHAMFERED SURFACES
OF THE NUT IN CONTACT WITH THE CLUTCH
Locking torques (N*m)
Nut locking clutch unit on pulley 55 ÷ 60 Nm
Refitting the driven pulley
-Refit the driven pulley assembly, the clutch bell
and the nut, using the specific tool.
Specific tooling
020565Y Flywheel lock calliper spanner
Locking torques (N*m)
Driven pulley shaft nut 40 to 44 Nm
NRG Power DT Engine
ENG - 9

PIAGGIO NRG Power DT Specifications

General

Brand	PIAGGIO
Model	NRG Power DT
Category	Scooter
Language	English