8.14
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
SPINDLES
SPINDLE REMOVAL
1. Raise the front of the snowmobile off the ground with
a dedicated sled lift or floor jack.
2. Remove the ski. Note the orientation of the bolt,
washers, and ski bumper.
3. Remove the steering tie rod end from the spindle.
Note the position of the washer under the rod end.
Discard the flange nut.
4. Remove the upper control arm spindle bolt, washers
and flange nut. Note the position of the washers.
Discard the flange nut.
5. Remove the lower control arm spindle bolt, washers,
and flange nut. Note the position of the washers and
bolt orientation. Discard the flange nut.
6. Remove the spindle.
STEERING / SUSPENSIONS
To Next Page
Loading...
Need help?
General
