Polaris GEM eLXD User Manual

5 - 47 ELECTRICAL
GEM Service Manual November 2007
LIGHT SWITCH REMOVAL
1. Remove the upper and lower dash panels. See
Body, section 7.
2. Remove steering column covers. See Body,
section 7.
3. Disconnect the pink and tan wires from the light
switch.
4. Looking at it from the rear, push tabs in with a
flat screwdriver, and press out front side.
5. To install a new switch from the front, insert the
switch in proper orientation and press firmly.
Switch will snap into place.
6. Connect wires and reassemble.
KEY SWITCH REPLACEMENT
1. Remove the upper and lower dash panels. See
Body, section 7.
2. Remove the RH and LH POD covers. See Pod
Covers in Body, section 7.
3. Disconnect electrical connector.
4. Loosen retaining nut and remove key switch.
5. Reverse the removal procedure to install.
ACCESSORY WIRING CHART
S1=F3
S2=F2
S3=F8
S4=F6
S5=FLASHER HAZARD (JUMP TO S4)
S6=F10
S7=F12
S8=F11
TURN SIGNAL SWITCH REPLACEMENT
1. Remove the upper and lower dash panels. See
Body, section 7.
2. Remove the RH and LH POD covers. See Pod
Covers in Body, section 7.
3. Remove the 2 screws.
4. Disconnect electrical connector and remove the
turn signal switch.
5. Reverse the removal procedure to install.
ROCKER SWITCH REPLACEMENT
1. Remove the upper and lower dash panels.
2. See Body Panels and Accessories.
3. Remove the RH and LH POD covers. See Pod
Covers in Body, section 7.
4. Mark the wires to aid in installation.
5. Disconnect the wires from the backside of the
rocker switch.
6. Release the tabs and remove the rocker switch.
7. Reverse the removal procedure to install.

Polaris GEM eLXD Specifications

General

Brand	Polaris
Model	GEM eLXD
Category	Utility Vehicle
Language	English