Polaris Sportsman 500 Service Manual

ENGINE
3.49
OIL PUMP REMOVAL/INSPECTION
1. Remove pump shaft bearing (A) and thrust washer (B)
from pump shaft.
2. Remove (2) bolts holding pump drive gear (C).
NOTE: On 500 H.O. models this gear is retained by (3)
bolts.
3. Inspect drive gear teeth for cracks, damage or
excessive wear.
4. Remove three oil pump retaining bolts and pump.
5. Inspect mating surface of crankcase and oil pump.
Check for nicks, burrs, or surface irregularities.
A
BC

Polaris Sportsman 500 Specifications

General

Brand	Polaris
Model	Sportsman 500
Category	Offroad Vehicle
Language	English