Polycom HDX Series Administrator's Guide

Administrator’s Guide for Polycom HDX Systems
3 - 12
Configuring Camera Settings and Video Quality Options
To configure camera and video settings:
1. Go to System > Admin Settings > Cameras > Camera Settings.
2. Configure these settings on the Cameras screen:
Setting Description
Camera 1 Specifies the camera’s aspect ratio:
•4:3 — Select if you are using a camera in standard mode.
• 16:9 — Select if you are using a camera in wide-screen
mode.
This setting also configures the following cameras to produce
the corresponding video format:
• Polycom PowerCam™ Plus
• Polycom PowerCam
• Polycom Eagle Eye
• Sony EVI-D100
• Sony BRC-300
Specifies the camera’s format:
• Component YPbPr — Select if the camera is connected
to the Polycom HDX system using a component cable.
•S-Video — Select if the camera is connected to the
Polycom HDX system using an S-Video cable.
• Composite — Select if the camera is connected to the
Polycom HDX system using a composite video cable.
Name Specifies a name and icon for the camera.
Video Quality Specifies Motion or Sharpness for the video input.
•Motion — This setting is for showing people or other
video with motion.
• Sharpness — The picture will be sharp and clear, but
moderate to heavy motion at low call rates can cause
some frames to be dropped. Sharpness is available in
point-to-point H.263 and H.264 calls only.
Detect Camera Detects any supported PTZ camera connected to Polycom
HDX system video input 1, and configures the camera
settings accordingly.

Polycom HDX Series Specifications

General

Brand	Polycom
Model	HDX Series
Category	Conference System
Language	English