The SoundStructure VoIP Interface
12 - 53
1. In the SoundStructure VoIP Interface Network settings on the Wiring
Page, set the DHCP boot server to Static and set the Provisioning Server
Settings to use an FTP Server and enter the appropriate server address,
username, and password.
2. Copy the new software file to the directory specified in step 7 of installing
the FTP server. The software file will have a name of the form
3111-33215-001.sip.ld where 3111-33215-001 is the part number associated
with the SoundStructure VoIP Interface software.
3. Copy the file 000000000000.cfg file to the directory specified in step 7 of
installing the FTP server. This configuration file tells the SoundStructure
VoIP Interface which firmware file to look for when it connects to the FTP
server. The contents of this configuration file must have at least the
information shown below for the SoundStructure VoIP Interface to find
and upload the desired sip.ld software file. The SoundStructure VoIP
Interface will know to look for a file named 3111-33215-001.sip.ld or sip.ld
based on the file contents shown next.
To Next Page
Loading...
Need help?
General
