© 2016 by Proceq SA 24
Piccolink Software (only for Piccolo 2)
1. Safety and Liability
1.1. Safety and Usage Precautions
This manual contains important information on the safety, use and maintenance of the Piccolink
software. Read through the manual carefully before the first use of the software. Keep the manual in
a safe place for future reference.
1.2. Liability and the “Software License Agreement”
Our “General Terms and Conditions of Sale and Delivery” apply in all cases.
All information contained in this documentation is presented in good faith and believed to be correct.
Proceq SA makes no warranties and excludes all liability as to the completeness and/or accuracy of
the information.
The subject of the license is the software that Proceq dispatches to the customer by electronic means,
in the version as sent and in the form as received by the customer. Proceq accepts no responsibility
for any properties of the software, either general or in terms of its suitability for any particular purpose.
The customer carries the risk that the software may not meet his expectations in terms of results or
performance. Proceq shall also not be liable for any damage suffered by the customer or third party
irrespective of whether the damage is the direct or indirect consequence of installing or using the
software or is in any way connected with installation or use of the software. In particular, Proceq shall
not be liable for loss of earnings, profit or savings, or for loss of or damage to software or data. This
applies even if Proceq is expressly made aware of such risks. Exclusion of liability applies in particular
to all direct, indirect or consequential damage that may arise to the customer because the software
fails to function properly or at all for whatever reason.
2. Installing the Piccolink Software
2.1. Installing Piccolink
• Insert the Equotip CD into the computer.
• Launch the “PICCOLINK_Setup.exe” file from the folder …\Equotip Piccolo 2\ Piccolink Soft-
ware\ on the CD.
• Follow the on-screen instructions.
• When the dialog box “Completing the Piccolink Setup Wizard” is displayed, make sure the check
box “Launch Piccolo 2 USB Driver Install” is selected before you press “Finish”.
To Next Page
Loading...
Need help?
General
