Quantum QX Series User Manual

Chapter 5: Troubleshooting
Isolate Replication Faults
QX and QXS Setup Guide 146
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
No Communication
link is down
l Verify RAID chassis cabling.
l Review event logs for indicators of a specific fault in a host or replication
data path component.
In the footer, click the events panel and select Show Event List. This will
open the Event Log Viewer panel.
l Verify valid IP address of the network port on the remote system.
l Click in the Volumes topic, then click on a volume name in the volumes
list. Click the Replication Sets tab to display replications and associated
metadata.
l Alternatively, click in the Replications topic to display replications and
associated metadata.
Table25:Replication Image
Can you create a replication set?
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
No On RAID chassis
with iSCSI host
interface ports,
replication set
creation fails due
to use of CHAP.
If using CHAP (Challenge-Handshake Authentication Protocol), see
the topics about configuring CHAP and working in replications within
the V3 disk management guide.
Table26:Replication Set

Quantum QX Series Specifications

General

Brand	Quantum
Model	QX Series
Category	Storage
Language	English