R&S LCX Series User Manual

Network operation and remote control
R&S
®
LCX Series
157User Manual 1179.2260.02 ─ 02
The R&S LCX supports CDC and TMC communication, see Chapter 10.2.2, "USB
interface", on page 144.
Note: If you change the "USB Class", you must reboot the instrument to load the corre-
sponding USB driver, see "Selecting the USB communication class protocol"
on page 162.
Remote command:
INTerfaces:USB:CLASs on page 215
10.3.6 GPIB settings
Option: R&S NG-B105 GPIB (IEC 625/IEE 488) bus interface
For remote control over GPIB, you can address the R&S LCX over a channel address.
Access:
1. Press the [settings] key at the front panel.
2. In the device settings menu, select "Interfaces".
3. Select "GPIB Address".
Figure 10-8: GPIB address on-screen keypad
The controller must address the instrument with the GPIB bus address.
The remote commands required to configure the network remotely are described in
Chapter 11.15, "SYSTem subsystem", on page 211.
GPIB Address
Set the GPIB channel address of the connected instrument.
About: see Chapter 10.2.3, "GPIB interface (IEC/IEEE bus interface)", on page 145
How to: see "Assigning the GPIB address manually" on page 163
Remote access settings

R&S LCX Series Specifications

General

Brand	R&S
Model	LCX Series
Category	Measuring Instruments
Language	English