To Next Page

To Previous Page

Getting started

R&S

LCX Series

16User Manual 1179.2260.02 ─ 02

4 Getting started

This chapter contains the same information as the getting started manual.

4.1 Preparing for use

Here, you can find basic information about setting up the product for the first time.

4.1.1 Lifting and carrying

See "Lifting and carrying the product" on page 9.

4.1.2 Unpacking and checking

1. Unpack the R&S LCX carefully.

2. Retain the original packing material. Use it when transporting or shipping the

R&S LCX later.

3. Using the delivery notes, check the equipment for completeness.

4. Check the equipment for damage.

If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.

See also: Chapter 13, "Transporting", on page 224.

4.1.3 Choosing the operating site

Specific operating conditions ensure proper operation and avoid damage to the prod-

uct and connected devices. For information on environmental conditions such as ambi-

ent temperature and humidity, see the data sheet.

See also "Choosing the operating site" on page 10.

Electromagnetic compatibility classes

The electromagnetic compatibility (EMC) class indicates where you can operate the

product. The EMC class of the product is given in the data sheet under "General data".

●

Class B equipment is suitable for use in:

– Residential environments

– Environments that are directly connected to a low-voltage supply network that

supplies residential buildings

Preparing for use

R&S LCX Series User Manual

Other manuals for R&S LCX Series