Instrument functions
R&S
®
LCX Series
95User Manual 1179.2260.02 ─ 02
2. In the "Functions" tab, select "Logging".
Figure 8-20: Network settings dialog
The settings dialog contains the basic parameters for setting the logging mode,
and provides access to file management parameters.
The required remote commands are described in Chapter 11.12, "LOG subsystem",
on page 200.
How to: see Chapter 8.8.3.2, "Using the logging function", on page 97.
Enabled.........................................................................................................................95
Save Location............................................................................................................... 95
Target Folder.................................................................................................................96
Mode............................................................................................................................. 96
Interval.......................................................................................................................... 96
Count.............................................................................................................................97
Duration.........................................................................................................................97
Start Time......................................................................................................................97
└ Set Date & Time..............................................................................................97
Enabled
Activates data acquisition and saving the readings.
Remote command:
LOG[:STATe] on page 204
Save Location
Accesses a dialog where you can select how to determine the location for the file.
Specific instrument functions
To Next Page
Loading...
Need help?
General
