R&S LCX Series User Manual

Remote control commands
R&S
®
LCX Series
171User Manual 1179.2260.02 ─ 02
11 Remote control commands
In the following, all remote-control commands are presented in detail with their param-
eters and the ranges of numerical values.
For an introduction to remote control and the status registers, see:
●
Chapter 10, "Network operation and remote control", on page 139
●
Chapter 10.2.4, "Status reporting system", on page 146
See also the list of commands in alphabetical order at the end of this user manual.
11.1 Conventions used in SCPI command description
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S LCX follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an Asynchronous
command.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (*RST
command) are indicated as *RST values, if available.
●
Factory preset values
Default parameter values that are reset only by factory preset.
●
Default unit
The default unit is used for numeric values if no other unit is provided with the
parameter.
●
Manual operation
If the result of a remote command can also be achieved in manual operation, a link
to the description is inserted.
Conventions used in SCPI command description

R&S LCX Series Specifications

General

Brand	R&S
Model	LCX Series
Category	Measuring Instruments
Language	English