REPLIGEN ACSS-20K User Manual

KrosFlo® TFF System – Auxiliary Scale ACSS-20K
User Guide
23 repligen.com 420-14871-001 Rev. 00
1. Enter <P3.Func> menu and select a given working mode.
2. Enter <Int> function, window for enter time interval value is displayed.
3. Press key to confirm, next return to home screen.
11.2.4 Lo threshold
<Lo> parameter allows to configure the function of automatic operation. The next measurement is
saved only when mass indication gets below the set net value of Lo threshold parameter.
1. Enter <P3.Func> menu and select a given working mode.
2. Enter <Lo> function, window for enter Lo threshold value is displayed.
3. Enter respective value and press key to confirm, next return to home screen.
12. Working mode – Weighing
<UUGG> is a standard working mode to carry out the weighing operation along with record of the
result to the database.
12.1 Local settings
To go to local settings, enter <3.1.UUGG> submenu.
Table 12. Weighing – Local settings
Submenu
Setting
3.1.1.Acc
Working mode accessibility
3.1.2.Snn
Save mode
3.1.3.Int
Time interval
3.1.4.Lo
Lo threshold
13. Working mode – Parts Counting
Parts Counting is a working mode enabling to determine quantity of small pieces of the same mass,
which determination is done on the basis of mass of sample piece (single part), and where the
sample piece mass (single part mass) is determined using the weighing device.
13.1 Local settings
To go to local settings, enter <3.2.PcS> submenu.
Table 13. Parts Counting – Local settings
Submenu
Setting
3.2.1.Acc
Working mode accessibility
3.2.2.UUt
Operation mode
3.2.3.Snn
Save mode
3.2.4.Int
Time interval
3.2.5.Lo
Lo threshold

REPLIGEN ACSS-20K Specifications

General

Brand	REPLIGEN
Model	ACSS-20K
Category	Scales
Language	English