Special Senders to Treat Differently
143
4
Programming Bypass Tray Paper Size
This section describes how to program Bypass tray Paper Size.
A Press [Bypass Tray Paper Size].
You can select a size from [Auto Detect], [Standard Size], or [Custom Size].
If you select [Auto Detect], proceed to steps
B
and
G
.
If you select [Standard Size], proceed to steps
B
,
C
and
G
.
If you select [Custom Size], proceed to steps
B
and
D
to
G
.
B Select the size you want to program.
If you select [Auto Detect], the machine recognizes the paper size automatically.
The machine will detect the paper size for the bypass tray as the short edge of
the paper is inserted into the machine. Even if you place an A4 size sheet in
theK orientation, the machine will detect it as A3L.
If you select [Standard Size], select a paper size displayed, and then proceed to
step
G
.
If you select [Custom Size], proceed to step
D
.
C Select the size you want to program from the sizes shown.
D Make sure that [Vertical] is selected.
E Enter the vertical size of the paper using the number keys, and then press
the {q} key.
Specify a vertical size from 210 mm (8.3") to 297 mm 11.6"). You cannot enter
a size smaller than 210 mm or larger than 297 mm.
Each time you press [mm] or [inch], the units switch between “mm” and
“inch”. If you enter a length and change the units by pressing [mm] or [inch],
it is converted automatically (fractions are rounded off).
To Next Page
Loading...
Need help?
General
