Attaching Hard Disk Drive Type 4000
45
3
Attaching Hard Disk Drive Type 4000
CAUTION:
Important
❒ Before touching the hard disk
drive, touch something metal to
discharge any static electricity.
Static electricity can damage the
hard disk drive.
❒ Do not subject the hard disk drive
to physical shocks.
❒ Before using the new hard disk
drive, you must make the settings
in the printer driver.
A Check the package contains the
following:
❖ Hard Disk Drive
❖ Flat Cable
❖ Power Cable
❖ Four Screws
B Turn off the power, and then un-
plug the power cable.
C Loosen the three screws securing
the controller board.
The screws cannot be fully re-
moved.
• Do not touch the inside of the
controller board compartment.
Doing so may cause a machine
malfunction or a burn.
AET083S
AKQ005S
AET085S
AET086S
AET063S
GaiaP1GB_Setup-F4_FM_forPaper.book Page 45 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
Need help?
General