Configuration
72
5
IEEE 1394 Configuration
Use this procedure to configure the
printer for use in an IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items appear in
the “Host Interface” menu.
Note
❒
If DHCP is in use, “IP Address1394”
and “Subnet Mask1394” are auto-
matically set.
IP over 1394
A Press the {Menu} key.
“Menu” appears on the display.
B Press the {U} or {T} key to dis-
play “Host Interface” menu, and
then press the {# Enter} key.
The interface setting menu ap-
pears.
C Press the {U} or {T} key to dis-
play “IEEE 1394 Setup”, and then
press the {# Enter} key.
The IEEE 1394 setting menu ap-
pears.
D Press the {U} or {T} key to dis-
play “IP over 1394”, and then
press the {# Enter} key.
The IP over 1394 setting menu ap-
pears.
E Press the {U} or {T} key to select
either “Active” or “Not Active”,
and then press the {# Enter} key.
After the settings are made, about
two seconds later, the screen re-
turns to the IEEE 1394 setting
menu.
F Assign the IP address to the print-
er. Press the {U} or {T} key to dis-
play “IP Address1394”, and then
press the {# Enter} key.
The current IP address appears on
the display.
Setting Name Value
DHCP On
IP Address1394 011.022.033.044
Subnet Mask1394 000.000.000.000
IP over 1394 Active
SCSI print Active
Bidi-SCSI print Active
AET005S
Menu:
Host Interface
IP over 1394:
*Active
GaiaP1GB_Setup-F4_FM_forPaper.book Page 72 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
Need help?
General