Sending Scan Files by E-mail
24
1
Specifying the E-mail Sender
This section explains how to specify the e-mail sender.
To send e-mail, you must specify the name of the sender.
You can specify the e-mail sender by any of the following methods:
• Select the sender from the sender list
• Select the sender by entering the registration number
• Select the sender by searching the machine’s address book
Note
❒ Senders must be registered in advance under [System Settings]. For details, see
General Settings Guide.
❒ In [System Settings], you can specify the Administrator's E-mail Address as the
default sender name. This lets you send e-mail without specifying the sender.
For details, see General Settings Guide.
❒ Depending on the security setting, the logged-on user may be specified as the
sender.
❒ When a protection code has been set, a screen for entering the protection code
appears after selecting the sender. Enter the protection code, and then press
[OK]. If the protection code you entered is correct, the sender name is dis-
played.
Selecting a Sender from the List
This section explains how to select the sender from the machine’s sender list.
A Press [Attach Sender's Name].
To Next Page
Loading...
Need help?
General