English
9
English
Usage Notice
ABOUT THE LAMP
■ Warning- When the lamp reaches the end of its life, it will burn
out and may make a loud popping sound. If this hap-
pens, the projector will not turn back on until the lamp
module has been replaced. To replace the lamp, follow
the procedures listed under “Replacing the Lamp”.
■ Warning- Before replacing the lamp, turn off the power and
wait at least one hour to allow the machine to cool
completely. If it is not completely cool, you may burn
or injure yourself due to the inside of the machine and
lamp unit being hot. If you replace the lamp without
unplugging the power cord from the power outlet,
electric shock or explosion may occur.
■ Warning- Be careful when handling the used lamp so that it
does not break. If it breaks, it may cause injury.
■ Caution- This projector will detect the life of the lamp itself. Be
sure to change the lamp when it shows warning mes-
sages.
■ Caution- The machine’s light uses a mercury vapor lamp that
becomes high pressure when it is turned on. The lamp
has the following characteristics, so be sure to handle
it with care after understanding the contents. If the
lamp explodes and you are either injured from broken
pieces of glass, think you have gotten glass particles
or mercury vapour in your eyes, or have inhaled glass
particles or mercury vapour, contact a doctor immedi-
ately.
■Deterioration or shock can cause the lamp’s life span
to end or the lamp to explode. If the lamp explodes, it
may make a big noise.
■The time that it takes for the lamp to reach its life
span or explode depends on each individual lamp and
its operating conditions. It is possible that it might
explode the rst time it is used.
■If you use the lamp past its replacement period, the
possibility of explosion increases.
■If the lamp explodes, broken glass pieces may be
scattered around the inside of the machine and ejected
from the vent or other opening.
■If the lamp explodes, a very small amount of mer-
To Next Page
Loading...
Need help?
General
