• If you are using Scan to Folder, create the destination folder on the computer's hard drive and
make it a shared folder. For details, see your operating system's documentation.
• To cancel scanning, press the [Scanner] key, and then press the [Stop/Clear] key.
Basic Operation for Scan to USB
• This machine does not support the use of USB flash drives connected to external USB hubs. Insert
your USB flash drive directly into the USB flash drive port located at the top left corner of the
machine.
1. Press the [Scanner] key.
2. Insert your USB flash drive into the USB flash drive port.
The message "To USB Memory" appears on the display.
3. Place the original on the exposure glass or in the ADF.
4. Press the [Start] key.
• To cancel scanning, press the [Stop/Clear] key.
• When using the exposure glass, place the next original on the exposure glass, and then press
the [1] key. Repeat this step until all originals are scanned.
When all originals have been scanned, press the [2] key to start sending the scanned file.
5. Confirm that "Sending..." appears on the display.
The scanned file is created in the root directory of the USB flash drive.
6. Remove the USB flash drive from the machine.
5. Scanning Originals
76
To Next Page
Loading...
Need help?
General
