3
3. Operation Flow
To use the unit, follow the procedure described below to carry out cutting. See the pages specified for explanations of each method
of operation.
6. Install a blade holder in the tool carriage.
4. Make other required settings.
3. Select the instruction set.
1. Set up the unit.
Must be performed before
using the device for the first
time.
Performed whenever the op-
erating environment is
changed.
Under normal operating con-
ditions, cutting can be per-
formed by following these
steps.
Explanation of Display Menu on page 20
5. Attach the material.
2. Connect the device to the computer.
7. Adjust the height of the tool holder.
8. Turn on the power.
9. Set the cutting area.
10. Run the cutting test.
11. Set cutting conditions.
12. Download cutting data from the computer.
13. Conclution.
Material Set-up on page 6,7
Installing the Blade on page 8
Setting the Cutting Area on page 9,10
Setting the Cutting Area on page 9,10
Cutting Test on page 11,12,13
Explanation of Display Menu on page 14—20
After Cutting on page 13
Downloading Cutting Data on page 13
This should be done when
loading a thick material.
Adjusting the Height of the Tool Holder
on page 9
Cutting Test on page 11
Explanation of Display Menu on page 16
Explanation of Display Menu
on page 16—20
Setting UP and Connectionon page 4,5
Setting UP and Connectionon page 4,5
To Next Page
Loading...
Need help?
General