6
5. Material Set-up Example
An example of material set-up is given below. Make your settings in accordance with the type of material you are using.
Use the included CP-A3
- Do not use the CP-A3 if you are planning to cut clean through the material. If you cut right through to the CP-
A3, you will no longer be able to use it.
- The peel-off sheets are used to protect the CP-A3 after use. Do not throw them away.
2. Remove the peel-off sheet from the face of the CP-A3, and attach your material to the surface of the CP-A3.
1. Peel off the backing sheet from the CP-A3, and attach it to the cutting table.
CP-A3
Material
If you are trying to secure large material, use two sheets of CP-A3 or whatever it takes to get the job done.
One CP-A3 can be used about 100 times. Replace it once it loses its grip (stickiness).
Using commercial double-sided tape
- Refrain from using double-sided tape that can cause damage to your material (peel off bits of material, put holes
in it , etc.).
- Make sure the sections to which you have not attached tape do not stick up from the cutting table.
Attach double-sided tape to the bottom of your material, and secure it as is to the cutting table.
To Next Page
Loading...
Need help?
General