30
3-6 When Cutting is Completed
When not in use for extended
periods, unplug the power cord from
the electrical outlet.
Failure to do so may
result in danger of
shock, electrocution,
or fire due to
deterioration of the
electrical insulation.
NOTICE
Remove the Material
Tool carriage
Tool securing screw
UNSETUP
POWER LED goes out
2
Lower the sheet loading levers and remove the
material.
3
(1) Loosen the tool securing screw on the tool
carriage.
(2) Remove the blade holder from the tool carriage.
4
Press the pin and remove the blade from the blade
holder.
As debris of material or paste might cling to the tip of
a used blade, wipe it with a soft cloth to remove them.
1
Press the [MENU] key several times until the screen
shown in the figure appears, then press the [ENTER]
key.
The tool carriage moves to right edge and the loaded
material is released. This is the “unsetup” state.
5
Turn off the power.
Blade
Blade holder
Press the pin.
Never leave the tool securing screw tightened. Tightening the screw makes it more difficult to install the
blade holder.
Never leave the machine with the pinch rollers lowered. The rollers may deform, making normal material
feed impossible.
To Next Page
Loading...
Need help?
General