74
Er1:
WRONG COMMAND
Er2:
WRONG NO.S
Er3:
OUT OF RANGE
Er15:
RS-232ERR
8-3 Error Messages
An error message will appear if incoming data has any of the errors listed in table. However, the error is shown in the display for
informational purposes, the data transfer continues and you are allowed to perform the next operation.
To clear the display, press any key.
If an error occurs, correct cutting may become impossible.
The error messages that may appear on the display are described below.
In almost all cases, the cause is receiving incorrect data. For information about corrective action, go to “8-2 What to Do If...” and
refer to “GX-500/400/300 Troubleshooting.”
Error massage Meaning
Appears if an instruction that the machine cannot interpret is sent.
Appears if the number of parameters differs from the permissible number.
Appears if the value specified for a parameter is out of the permissible range.
Appears if framing error, parity error or overrun error occur when data is perceived.
To Next Page
Loading...
Need help?
General