40
Using the Sequencer to Create a Song
8
When you finish recording, press [STOP/PLAY].
The [REC] indicator goes dark.
9
Press [ARPEGGIO] to make its indicator light go out.
10
Press [RESET] to return to the first measure, and then press [STOP/
PLAY] to play the song back and verify that your bass part was
recorded correctly.
Use the Keyboard to Record a Melody Track
Finally, we’ll play the keyboard to record the melody track while listening to the
drums and bass you’ve already recorded.
1
Make sure that Multitimbre “PRST: 05 Pop” is selected and that the
MULTITIMBRE PLAY screen is displayed.
2
Move the cursor to the part list, and press or to select Part 1
(the melody track).
Next to Part 1, you can see “ ” symbol. This symbol shows that Part 1 is the
currently selected part (current part).
fig.Q-48
3
Press [REC].
The [REC] indicator blinks, and the Recording Standby window appears.
4
Make sure that the various parameters of the Recording Standby
window are set correctly (p. 38).
If you are not satisfied with the
realtime recording you just
made, you can press [MENU],
and from the Menu window
that appears, select “Undo
Realtime Recording” to return
to the state prior to recording
(Undo).
To Next Page
Loading...
Need help?
General
