Getting Ready
Turning the Power On and O
Turning the Power On
NOTE
Once everything is properly connected (p. 10), be sure to follow
the procedure below to turn on their power. If you turn on
equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Move the [VOLUME] slider all the way to the left to
minimize the volume.
Minimize the volume.
2. Press the [ ] switch.
The unit turns on and a TONE button along with other buttons light
up.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally.
3. Move the [VOLUME] slider to adjust the volume (p. 8).
* Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal
and does not indicate a malfunction.
Turning the Power O
1. Move the [VOLUME] slider all the way to the left to
minimize the volume.
2. Press and hold the [ ] switch until the display turns o.
The unit turns o.
Concerning the Auto O function
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto
O function). If you do not want the power to be turned o
automatically, disengage the Auto O function (p. 33).
• Any settings that you are in the process of editing will be lost
when the power is turned o. If you have any settings that you
want to keep, you should save them beforehand.
• To restore power, turn the power on again.
Listening to the Demos
Here’s how to listen to the demo songs.
1. While holding down any TONE button, press the
[ ] button.
Demo playback starts.
MEMO
The tone used for the demo song depends on which TONE
button you press.
When the last demo has nished, playback starts again from the
rst demo.
2. To terminate demo play, press the [ ] button.
* The demo songs are for your personal enjoyment only.
Unauthorized use is a violation of applicable laws.
* No data for the music that is played will be output from the MIDI
OUT connector.
13
Operation Guide Getting Ready Performing Recording Registrations Settings
Appendix
To Next Page
Loading...
Need help?
General
