11
Setting Up the Kit
1.
Attach the stand holder (included with the optional drum stand) to the TD-3.
Using the screws attached to the bottom panel, attach the holder so the unit is oriented as shown in the
diagram.
ONLY Use the 8 mm screws (M5 x 8) provided with the TD-3. Other screws may damage
the unit.
fig.P-001.e
When turning the unit upside-down, get a bunch of newspapers or magazines, and place
them under the four corners or at both ends to prevent damage to the buttons and controls.
Also, you should try to orient the unit so no buttons or controls get damaged.
When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to
fall or tip over.
2.
Attach the TD-3 and stand holder to the drum stand (such as the optional MDS-3C).
See the owner’s manual for the stand for details on assembling the drum stand and attaching the TD-3.
The optional APC-33 All Purpose Clamp can be attached to a pipe of 10.5mm–30 mm radius
in case you want to mount the TD-3 on a cymbal stand or other such stand.
Mounting the TD-3 on the Stand
TD-3_e.book 11 ページ ２００７年９月１８日 火曜日 午後２時４０分
To Next Page
Loading...
Need help?
General