25
Creating Your Own Drum Kit
Every sound in the kit assigned to a pad or pedal has individual level (volume) and pan (position) controls.
When using rim- and edge-capable pads, you can adjust the level for the head (or bow) and rim (or edge)
individually.
Pan position for the head (bow) and rim (edge) are the same however.
fig.01-005a
1.
Press [LEVEL/PAN].
[LEVEL/PAN] flashes.
2.
Hit the pad you wish to set.
The trigger indicator for the struck pad lights up, and the level or pan value appears in the display.
When the rim (edge) is struck, the rim indicator lights up.
3.
Press [LEVEL/PAN] and [+] or [-] to set the level or pan.
The level and pan values alternate in the display each time [LEVEL/PAN] is pressed.
fig.01-005.e
When holding down [+] and pressing [-] values increase rapidly.
When holding down [-] and pressing [+] values decrease rapidly.
(When using the above mentioned, “quick” mode, the pan value will stop once it reaches “Ctr.”)
LEVEL:
0–15
PAN:
L15 (left)–Ctr (center)–r15 (right)
4.
Repeat Steps
2
and
3
to make the settings for other pads or pedals.
5.
When you’re finished, press [DRUM KIT]; the [LEVEL/PAN] light goes off.
Do not turn off the power without the [LEVEL/PAN] light having gone out. Otherwise you
will lose the changes you have just made.
Instrument Volume & Pan [LEVEL/PAN]
31, 3
Level
Pan
Switches each time
[LEVEL/PAN] is pressed
TD-3_e.book 25 ページ ２００７年９月１８日 火曜日 午後２時４０分
To Next Page
Loading...
Need help?
General