14
Setting Up the Kit
* Once the connections have been completed (p. 12, p. 13), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and
other devices.
fig.P-006
1.
Turn the VOLUME knob on the TD-3’s rear panel completely to the left to lower the volume to “0.”
2.
Turn down the volume control on the connected amp or audio system.
3.
Set the POWER switch to the “ON” position to turn on the power.
* Always make sure to have the volume level turned down before switching on power. Even with the volume all the
way down, you may still hear some sound when the power is switched on, but this is normal, and does not
indicate a malfunction.
4.
Turn on the power to the connected amp or audio system.
5.
While hitting a pad, gradually turn the VOLUME knob to the right to adjust the volume level.
Turning On/Off the Power
1, 5
3
Precautions When Turning on the Power
fig.P-007
After the power is turned on, the drum kit
number appears in the display; do NOT hit any
pad or press any pedal until [DRUM KIT] has
lighted. Doing so can cause triggering problems.
TD-3_e.book 14 ページ ２００７年９月１８日 火曜日 午後２時４０分
To Next Page
Loading...
Need help?
General