57
Pad and Trigger Settings
When two pads are mounted on the same stand, hitting one pad may trigger the sound from another pad
unintentionally (This is called
crosstalk
.) Eliminate this by adjusting Crosstalk Cancel on the pad that is
sounding inadvertently.
1.
Hold down [LEVEL/PAN] and press [TEMPO].
[EDIT] flashes.
2.
Press [EDIT] a few times until “ ” is displayed.
“ ” appears in the display, then the crosstalk cancel value is indicated.
3.
Hit the pad you wish to set.
The trigger indicator for the struck pad lights.
If the hi-hat cymbal also sounds when hitting a snare pad, set the Crosstalk Cancel for the pad being used
for the hi-hat. As this value is raised, the hi-hat cymbal pad will be less prone to receive crosstalk from
other pads.
4.
Press [+] or [-] to adjust the value.
Crosstalk Cancel:
OFF, 20, 25, 30, 35, 40, 45, 50, 55, 60, 65, 70, 75, 80
Crosstalk Example: If you hit the snare pad and the hi-hat cymbal also sounds
Raise the “Xtalk Cancel (Crosstalk Cancel)” for the pad being used for the hi-hat. The hi-hat cymbal pad
will be less prone to receive crosstalk from other pads.
If the value is set too high, and two pads are played simultaneously, the one that is struck less forcefully
may not sound. Be careful and set this parameter to the minimum value required to prevent crosstalk.
With a setting of “OFF,” crosstalk prevention will not work.
5.
Press [EDIT] to continue editing other settings.
6.
When you’re finished, press [DRUM KIT]; the [EDIT] light goes off.
Do not turn off the power without the [EDIT] light having gone out. Otherwise you will lose
the changes you have just made.
You can also make the settings using the procedure on p. 41.
Eliminate Crosstalk Between Pads (Crosstalk Cancel)
TD-3_e.book 57 ページ ２００７年９月１８日 火曜日 午後２時４０分
To Next Page
Loading...
Need help?
General