26
Converting Signals
Signals input to the VC-30HD are output from the i.LINK connector and USB connector
on the rear panel. Use the button at [OUTPUT FORMAT] to select the output format.
The VC-30HD does not support up/down scalling, interlace/progressive (I/P) conversion, or frame-
rate conversion. The [OUTPUT FORMAT] indicators flash when the input and output formats are not
compatible, such as the scenarios shown below. No output is possible while the [OUTPUT FORMAT]
indicators are flashing.
• When 1080i component input is selected as the source and DV is selected as the output format.
• When NTSC S-Video input is selected as the source and HDV is input as the output format.
This section describes the source settings. For information on button operations, refer to
“About Button Operations” (p. 17).
When an analog video source has been selected, the audio source selected using
[AUDIO INPUT] is embedded to the output. L and R cannot be exchanged.
Converting from Component
Use [VIDEO INPUT] to select [COMPONENT].
fig.component-convert.eps
Converting from S-Video
Use [VIDEO INPUT] to select [S-VIDEO].
fig.S-Video-convert.eps
Converting from Composite
Use [VIDEO INPUT] to select [VIDEO].
fig.composite-convert.eps
Converting Analog Input
To Next Page
Loading...
Need help?
General
